Interlogix Monitor XL Hardware Guide Bedienungsanleitung Seite 49
- Seite / 66
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
22-0375 rev1.1 Monitor ISM/xL™ Hardware Guide 45
MONITOR System Reference Topics
Adding Any Power Supply to the Module Bus
• An additional power supply’s positive is not connected to the main control module bus positive with an isolating
diode, as was previously done.
• The modules using power from the additional power supply have their module bus Data A and B interconnected as
normal.
• The additional power supply’s negative is connected common to the module bus negative.
• The additional power supply’s positive is never connected to the module bus positive.
Communication Connections between the Main Controller and the Director PC
Software
Direct Connect to PC
Main
Panel
Mother
board
1432
5
1432
CTS/RTS
RTS/CTS
DSR/DTR
DTR/DSR
RI/RI
CD/CD
TB14 TB15
green
black
132
TB16
0V
B
A
white
RS485
RX/RX
TX/TX
GND/GND
RS485 Communication Cable
Cable shield (do not ground at the PC)
To additional panels (maximum 30)
0V
B
A
Cable
Shield:
Connect to
the chassis/
earth
ground at
one panel
only (e.g.
1st or last)
black
white
green
NOTE: The
A and B
connections
here are
reversed
relative to
the panel(s).
P/N 120-3401 (24 AWG, 4wires, shielded)
1432
Currently
Supplied
Version
RS485
Converter
P/N
650-9061
DB9 (insert into
free serial port on
the specific PC)
NOTE:
The A and B
connections
are one to one.
DB9 (insert into
free serial port on
the specific PC)
Previous Version
RS485 Converter
P/N 11-0343
(+)12V
(-)0V
Data B
Data A
black
green
white
green
black
white
A
B
GND
+12V
GND
Additional power may be needed when
connecting multiple panels. Connect 12VDC
and parallel neg0Vgnd at either converter’s
terminal block.
Modem Connection for PC Communications
Main
Panel
Mother
board
1432
5
1432
CTS/RTS
RTS/CTS
DSR/DTR
DTR/DSR
RI/RI
CD/CD
TB14 TB15
green
black
132
TB16
0V
B
A
white
RS485
RX/RX
TX/TX
GND/GND
RS485 Communication Cable
Cable shield (do not ground at the modem)
To additional panels (maximum 30)
0V
B
A
Cable
Shield:
Connect to
the chassis/
earth
ground at
one panel
only
(e.g.
1st or last)
black
white
green
NOTE: The
A and B
connections
here are
reversed
relative to
the panel(s).
P/N 120-3401 (24 AWG, 4wires, shielded)
1432
Currently
Supplied
Version
RS485
Converter
P/N
650-9061
NOTE:
The A and B
connections
are one to one.
Previous Version
RS485 Converter
P/N 11-0343
(+)12V
(-)0V
Data B
Data A
black
green
white
green
black
white
A
B
GND
+12V
GND
Connect via DB9-
DB25 and
a null-
modem adapter
(or equiv.cable)
M
O
D
E
M
Connect via DB9-DB25 and a null-modem adapter (or equiv.cable)
Additional power may be needed when
connecting multiple panels. Connect 12VDC
and parallel neg0Vgnd at either converter’s
terminal block.
- Monitor ISM/xL 1
- Hardware 1
- Contents 3
- Foreword 4
- Monitor ISM 5
- Main Control Board 6
- Enter ID: 7
- Arming Station Reader 8
- Keypad Command Entries 9
- No Commands (Simple Access) 10
- With Commands 10
- IMPORTANT: 11
- Refer to 11
- Ratings / Requirements 11
- 2 Zone Wiring cont 12
- 8 Zone Wiring and Mounting 14
- Adding an Electronic Siren 15
- 22-0375 rev1.1 16
- Output/Relay Card 17
- Version 1 18
- normally 19
- Testing (Signal Strength) 20
- Version 2 Wireless 21
- NA Module Notes 22
- Interface Board 23
- Receiver 23
- V2 Module Programming 25
- ” screen for editing. The 27
- Fire Module 28
- Features: 29
- Graphic Map Module cont 30
- Smart / Vigil Module 31
- Vigil Module 32
- Programming Inputs/Outputs 33
- Checking Status 34
- Door Controller Modules 36
- Version 2 Door Module 37
- Multi-Door 38
- Controller 38
- First Elevator 41
- Connections 41
- Elevator 42
- Elevator Isolator Board 43
- WATERPIPE 45
- Communication Modules 46
- IP Module V3 47
- Direct Connect to PC 49
- Monitor xL 51
- Main Controller 52
- Feature Expansion Board 53
- CPU Failure 54
- ComsLost #50624ef 55
- Enter code 55
- Input Point Expanders 56
- 8 Transistor 57
- Expansion 57
- Module Power Supply 58
- • AC Mains failure 59
- • Battery loss 59
- Single Device 61
- Multiple Device 61
- Control Panel as follows: 62
- Exit 63
Verwandte Produkte und Handbücher für Schalttafel Interlogix Monitor XL Hardware Guide
Schalttafel Interlogix NX-4 Bedienungsanleitung
(44 Seiten)
(44 Seiten)
Schalttafel Interlogix NX-4 Bedienungsanleitung
(18 Seiten)
(18 Seiten)
Schalttafel Interlogix NX-6 Bedienungsanleitung
(18 Seiten)
(18 Seiten)
Schalttafel Interlogix NX-8 Bedienungsanleitung
(61 Seiten)
(61 Seiten)
Schalttafel Interlogix NX-8 Bedienungsanleitung
(18 Seiten)
(18 Seiten)
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.021 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern