Interlogix Monitor XL Hardware Guide Bedienungsanleitung PDF herunterladen (Seite 17)

22-0375 rev1.1 Monitor ISM/xL™ Hardware Guide 13

Output/Relay Card

312

COM

O/P9

312

312312 312

O/P10

O/P11

O/P12

O/P13

O/P15

O/P16

O/P14

COM

Relay 1



Relay 2

Annunciator output

board female plug

back of this board.

Mounting Holes

Screw into plastic

base posts at top of

Expander board.

Plug into Expander board male plug

used for 8 output/LED annunc. card

LED1

LED2

dual

normal

Follows relay2

Follows relay1

TB1 TB2

TB3

TB4

TB5

Form 'C' relays rated at 2 AMPS.

Current consumption = 70mA

with both relays/LEDs energized.

• Can be used in place of the 8-output/LED-annunciator card on 8 and 16 point Expander pods to reduce

installation of additional separate relays.

• Output 9 and 10 are relay outputs that can be configured the same as regular outputs but whose

contacts will change state upon activation.

• Outputs 11 to 16 act as standard voltage outputs that will turn 12VDC high upon activation.

• When using the card with the 8-pt. Expander, the pod is configured with 16 outputs and outputs 1 and 2

on the board can be programmed. Outputs 3 to 8 must be skipped, as they do not exist. Programming

for the card would then begin at 9 to 16.

• With the 16-pt. Expander, a full 16 outputs can be programmed.

Dual Action Relays

• When jumper J1 is in the lower position (dual), programming output 9 will cause both relays 1 and 2 to

trigger at the same time. Output 10 can not be programmed or used.

• When jumper J1 is in the upper position (normal), relay 1 will respond to output 9’s programming and

relay 2 will respond to output 10’s programming.

• In either jumper position, outputs 11 to 16 will react normally.

• If jumper J1 is not connected at all, relay 1 will follow output 9 but relay 2 and output 10 will not function

at all.

• LED 1 follows relay 1 when triggered and LED 2 follows relay 2 when triggered for Service use only.

NOTE: Also compatible with Chubb Smart Commercial Concentrator. Connected to a Chubb Smart alarm

system, card outputs would be 1 – 8. On a Smart commercial concentrator connected to a Fx/ISM Smart

Pod, card outputs would be the same as stated here, 9 – 16.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 65 66

Kommentare zu diesen Handbüchern

Keine Kommentare

Interlogix Monitor XL Hardware Guide Bedienungsanleitung Seite 17

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Schalttafel Interlogix Monitor XL Hardware Guide