Interlogix Monitor XL Hardware Guide Bedienungsanleitung PDF herunterladen (Seite 20)

16 Monitor ISM/xL™ Hardware Guide

22-0375 rev1.1

SENSOR

CATEGORY

DESCRIPTION DEFAULT

SETTINGS

Cnt Door Window Contact (surface mount)

- also used as an RF transmitter for hard wire inputs

- e.g. Overhead Door Contacts

.

FrP Fire Pull 3. .

Frz Freeze Temperature Detector 3..

Gls Glass Break Detector 3..

HKP Hand Held Keypad 0. .

PIR Passive Infra-red Detector 3..

Pnc Panic Pendant OR Hand Held Double Button Panic 0. .

Rcn Recessed Contact 3..

RoR Rate of Rise Detector 3. .

Smk Smoke Detector 3. .

SoS Shock and Sound Detector 3..

??? Unknown sensor type – delete this sensor and re-learn

Testing (Signal Strength)

• Use the Service PIN to go to the TEST menu.

• Select App for application module and then W/L for wireless.

• Select Scan. Activate a sensor.

• The screen will display information about each sensor it receives. E.g. Cnt56DB5 (door/window contact and its

address),

014 (input #14), 80 02 4 (sensor transmit codes).

• Press XESC escape to return to the TEST screen. Press Signal.

• Activate a sensor. Screen indicates signal strength of sensor it receives. E.g. “Strength is 8 !”. Signal strength of

7 to 8 is acceptable. Signal strength of 6 or less is poor to unacceptable. The input point # transmitting will also

indicate:

(Tx: 014).

• Another method to check if a sensor is transmitting is to stand near the RF module holding a sensor and activate

the sensor. The large green LED, visible through the module’s cover will flash upon activating the sensor to

indicate signal transmission.

• RF Module sensor inputs OK or Not OK and Tamper can be checked in System Status/Area/Points.

• RF Module, hand held keypad(s) and sensor status can be checked in System Status under App – Wireless

using the left or right arrow LCD keypad keys for conditions such as low battery, sensor loss. Disregard any codes

in lower right corner of these screens.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 65 66

Keine Kommentare

Interlogix Monitor XL Hardware Guide Bedienungsanleitung Seite 20