Interlogix TruVision IP Camera Configuration Manual Bedienungsanleitung PDF herunterladen (Seite 33)

2BChapter 3: Camera configuration

TruVision IP Camera Configuration Manual 29

Note: If you have configured the FTP settings and check Upload Picture in the

FTP tab, the snapshots will be uploaded to the FTP. If you also check Upload

Snapshot for motion detection or alarm input, the snapshots will be uploaded to

the FTP when motion detection or an alarm input is triggered.

To set up snapshots:

1. In the Events folder, click the Snapshot tab to open its window.

2. Check Enable Timing Snapshot to enable continuous snapshots. Check the

Enable Event-triggered Snapshot to enable event-triggered snapshots.

3. Select the desired quality of the snapshot.

4. Set the time interval between two snapshots.

5. Click Save to save changes.

NAS settings

You can use a network storage system (NAS) to remotely store recordings

To configure record settings, please ensure that you have the network storage

device within the network.

The NAS disk should be available within the network and correctly configured to

store the recorded files, log files, etc.

Notes:

1. Up to eight NAS disks can be connected to the camera.

2. The recommended capacity of NAS should be between 9G and 2T as

otherwise it may cause formatting failure.

Figure 12: NAS menu

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 53 54

Keine Kommentare

Interlogix TruVision IP Camera Configuration Manual Bedienungsanleitung Seite 33