Interlogix Concord Express Installation Manual Bedienungsanleitung PDF herunterladen (Seite 20)

Chapter 1

14 Concord Express Installation Instructions

Figure 7: Installing and connecting the HIM in the Concord Express

Connecting Detection Devices to Panel Zone Inputs

The panel comes with six factory programmed onboard hardwire zones (see

“Accessory Modules Menu” on page 60 for factory settings). Zone inputs 1

through 6 are supervised using a 2k-ohm, end-of-line resistor (included with

panel) at the last device on the circuit.

Note: Install an end-of-line resistor on all unused, factory programmed, onboard

panel zones.

All six zones accept either normally open (N/O) or normally closed (N/C)

detection devices (see Figure 8 on page 15).

The maximum loop resistance for each zone input is 300 ohms, plus the 2k end-

of-line (EOL) resistor.

Connecting Intrusion Detection Devices

Figure 8 on page 15 shows the typical wiring for N/C and N/O door/window

intrusion detection.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 116 117

Keine Kommentare

Interlogix Concord Express Installation Manual Bedienungsanleitung Seite 20