Interlogix NVR 50 User Manual Bedienungsanleitung PDF herunterladen (Seite 110)

11BChapter 12: Network settings

104 TruVision NVR 50 User Manual

from the NVR to the network management system.

Before configuring this function, you must first install the SNMP software.

To configure SNMP protocol settings:

1. Click the Network settings icon in the menu toolbar.

2. Click SNMP and enter the required settings.

3. Click Apply to save the settings.

Configuring the FTP server

This function is currently unavailable.

Configuring a remote alarm host

If a remote alarm host is set, the NVR sends a signal to the host when an alarm

is triggered. The remote alarm host must have the TruVision Navigator server

software installed.

To set up a remote alarm host:

1. Click the Network Settings icon in the menu toolbar.

2. Click More Settings.

3. Enter Alarm Host IP and Alarm Host Port.

Alarm host IP represents the IP of the remote PC where the Network Video

Surveillance software installed. The alarm host port value must be the same

as software’s alarm monitor port. Default port is 7200.

Configuring multicast

Setting up multicasting resolves limitation issues when streaming videos through

a network access device. A multicast address spans the Class-D IP range of

224.0.0.0 to 239.255.255.255. We recommend that the IP address range of

239.252.0.0 to 239.255.255.255 be used.

To set up multicasting:

1. Click Network Settings icon in the menu toolbar and then click More

Settings.

2. Enter a Multicast IP address.

Note: When adding a device to the Network Video Surveillance software, the

multicast address must be the same as the NVR’s multicast IP.

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 176 177

Keine Kommentare

Interlogix NVR 50 User Manual Bedienungsanleitung Seite 110