Interlogix TVC-6120-1 Quick Start Bedienungsanleitung PDF herunterladen

TVC-6110-1 / TVC-6120-1 Camera Quick Start

Guide

Introduction

This is the Quick Installation Guide for the TVC-6110-1-N(-P)/

TVC-6120-1-N(-P) camera.

Refer to the user manual for complete instructions on installing

and configuring this camera.

User guidelines

• Program the camera settings as much as possible before

mounting the camera. Take appropriate safety precautions

while completing programming after installation.

• Always use a 12 VDC or 24 VAC UL listed Class 2 power

supply to power the camera.

• Do not use the camera over the temperature range

specifications: -10°C to +50°C (14°F to 122°F)

• If the light source where the camera is installed

experiences rapid, wide- variations in lighting, the camera

may not operate as intended.

WARNING: To reduce the risk of fire or electronic shock, do

not expose the camera to rain or remove cover.

Description

Figure 1: Camera description

TVC-6110-1-N(-P)

1. OSD control button

2. Power LED

3. 12 VDC Power

4. Video output

5. Ground

TVC-6120-1-N(-P)

1. OSD control button

2. Alarm output/Ground

3. D/N switch (3.3V)

4. RS-485 ports (D+, D-)

5. Power LED

6. 12 VDC/24 VAC dual power

7. Video output

8. Ground

Installation

Please check the package contents and make sure that the

device in the package is in good condition and all the assembly

parts are included.

The camera is designed for both indoor and outdoor use. To

use the camera outdoors, it must be installed in an approved

outdoor housing.

Note: Before installing, please ensure that the mounting

surface is strong enough to withstand three times the weight of

the camera. If the wall is not strong enough, the camera may

fall and cause serious damage.

Install the camera

1. Attach the lens.

Refer to the instructions that came with the lens you

purchased for complete installation instructions of that

lens.

Screw the lens clockwise onto the lens mount of the

camera. Take care to prevent dust from entering between

the lens mount and the lens.

For optimal performance, please use an auto iris lens.

Plug the auto-iris drive cable to the 4-pin interface on the

side of the camera. The 4 pins are: 1. Damper -; 2.

Damper+; 3. Drive+; 4. Drive-



2. Connect the cables.

Connect a coaxial cable from the camera’s BNC connector

to a CCTV monitor or video recording device. Connect a

12 VDC or 24 VAC power supply to the power input.

Power supply

Monitor

1 2

Inhaltsverzeichnis

Seite 1 - Installation

Seite 2 - Menu map

2 / 2 P/N 1072544B-EN • REV 0.04 • ISS 21JUN12 Programming Once the camera hardware has been installed, it can then be configured. Program the cam

Kommentare zu diesen Handbüchern

Keine Kommentare

Interlogix TVC-6120-1 Quick Start Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Videoüberwachungssysteme Interlogix TVC-6120-1 Quick Start herunter. Interlogix TVC-6120-1 Quick Start User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Videoüberwachungssysteme Interlogix TVC-6120-1 Quick Start